From b10beb347238b153af8aa544fb276485b34e970e Mon Sep 17 00:00:00 2001 From: Russ Allbery Date: Sat, 5 Jan 2008 00:01:54 +0000 Subject: The wallet client can now get the server, port, principal, and remctl type from krb5.conf as well as from compile-time defaults and command-line options. --- README | 18 +++++++++++------- 1 file changed, 11 insertions(+), 7 deletions(-) (limited to 'README') diff --git a/README b/README index 6b95e16..13d2b89 100644 --- a/README +++ b/README @@ -136,14 +136,18 @@ BUILD AND INSTALLATION You can build and install wallet with the standard commands: - ./configure --with-wallet-server= + ./configure make make install The last step will probably have to be done as root. Currently, this - always installs both the client and the server. You must specify the - default wallet server at configure time unless you're at Stanford. This - will be replaced with real client configuration in a later release. + always installs both the client and the server. + + You can pass the --with-wallet-server and --with-wallet-port options to + configure to compile in a default wallet server and port. If no port is + set, the remctl default port is used. If no server is set, the server + must be specified either in krb5.conf configuration or on the wallet + command line or the client will exit with an error. By default, wallet installs itself under /usr/local except for the server Perl modules, which are installed into whatever default site @@ -250,9 +254,9 @@ CONFIGURATION configuration on your KDC if you want unchanging flag support, and set up a srvtab if you want AFS kaserver synchronization support. - The client currently has no configuration options and hard-codes the - wallet server and port at compile time. This will change in a future - release. + The wallet client supports reading configuration settings from the + system krb5.conf file. For more information, see the CONFIGURATION + section of the wallet client man page (man wallet). THANKS -- cgit v1.2.3